Categories

False alarms and system glitches can be exasperating, and even more concerning, may prevent your security system from doing its job effectively. Thankfully, most problems, from dead batteries to false alarms, are simple to remedy. Check out our tips for troubleshooting your home alarm system in Greensboro. We’ll help you keep your family members protected and your system running properly.

Test Your Home Security System In Greensboro

One of the best ways to troubleshoot your property’s security is to test it yourself! Newer systems have a test mode so you don’t accidentally initiate an emergency call. Once you’re in test mode, do the following:

• Activate your system as you normally would when heading out.
• Open a window or door protected by a contact sensor, or try to set off something else. Shut the door or window once you’re done so it doesn’t trip the alarm as you switch out of test mode.
• Let the alarm resonate for 60 seconds to ensure communications with the security provider and to make an entry in the alarm system log.
• Proceed to test equipment as you wish
• Review the system activity log to confirm that everything’s working.

No need to worry, monitoring professionals can see that your system is undergoing a test. Just be sure to switch out of test mode when you’re done. It’s smart to test every other month or whenever you adjust your home’s phone or internet connectivity.

Check The Positioning And State Of Motion Sensors

Although an crucial part of your alarm system, motion detectors are prone to false alarms. You can help prevent them with a few simple troubleshooting steps.

• Do a physical check. Is there something that could move within the sensor’s detection range, like drapery taken by a breeze?
• Is the sensor covered in dust? Cobwebs, dirt, and grime can cause issues. Make sure the sensor is clean.
• Does the motion detector offer pet immunity you can activate? Some sensors can be set to ignore pets weighing up to 100 pounds.
• When was the battery last replaced? Low batteries may impact performance or result in false alarms.
• Is the sensor facing a heat source? Excessive heat from direct sun or a fireplace can cause an alarm.

Keep Batteries On Hand And Pay Attention To Low Battery Warnings

One of the great aspects of the latest home security systems is that they’ll notify you when batteries are running low. If your system is equipped with a control panel or app, you’ll typically discover notifications there. Depending on your alarm, you may detect an intermittent beep when batteries are running out. 

Contact sensors, smoke detectors, motion sensors, and other wireless devices have batteries that should be replaced every so often. It’s a good idea to keep batteries around and set a replacement schedule. Many systems also have a rechargeable backup battery for the primary control panel. This battery keeps your system functioning if you have a power outage and should recharge itself once power is restored. If it doesn’t, you will have to replace it.

Troubleshooting Is Effortless With ADT Home Security In Greensboro 

As the leading name in home security, ADT builds systems that supply superior functionality and protection. Getting into test mode is simple through MyADT.com or the ADT+ app, and you’ll always receive updates when a battery is nearing depletion. Get in touch with Secure24 Alarm Systems, an authorized ADT dealer, to get more details and design a system perfectly suited to your Greensboro home. Place a call to (336) 306-5608 or submit our form today!